CAUTION:
Make sure that there is
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
.
To start the engine
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke lever to the choke position.
WARNING:
The cutting unit starts
to move immediately when you start the
engine with the choke.
3. Hold the body of the product on the ground with your
left hand.
4. Hold the starter rope handle with your right hand and
the throttle trigger and throttle trigger lockout with
your left hand.
5. Slowly pull out the starter rope with your right hand
until you feel some resistance.
WARNING:
Do not twist the starter
rope around your hand.
6. Pull the cord quickly and with force. Pull a maximum
of 5 times.
CAUTION:
Do not pull the starter
rope to full extension and do not let go of
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
7. Reset the choke when the engine fires.
8. Pull the starter rope again and again until the engine
starts.
9. Operate the throttle gradually when the engine
starts.
10. Make sure that the engine runs smoothly and let the
engine become warm for 1-2 minutes before
operation.
To stop the product
• Push the stop switch to stop the engine.
10
1695 - 001 - 24.06.2021
