RedMax G2500TS, Руководство владельца/оператора

Страница: 13 / 36

OP8
7. Operation
Once the choke knob has been pulled out, it will
not return to the operating position even if you
press down on it with your finger. When you wish
to return the choke knob to the operating position,
pull out the throttle lever instead.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorousl y. (OP6)
6. When firing occur, push in the choke knob and
pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
Before you start the engine, make sure the saw
chain is not contacting anything.
■
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure. (OP7)
(1) Chain oil
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch
side. Adjust according to your work conditions.
(OP8)
(1) Chain oil flow adjusting shaft
(a) Rich
(b) Lean
The oil tank should become nearly empty by the
time fuel is used up. Be sure to refill the oil tank
every time when refueling the saw.
NOTE
WARNING
NOTE
OP6
OP7
❲
13
❳