11. Cutting equipment
12. Cylinder and piston
13. Crankcase and crankshaft
14. Front handle
7.2 To clean and examine the product parts
•
Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
•
Replace damaged or defective parts.
•
Always use original spare parts.
7.3 Starter
7.3.1 To remove and install the starter unit
1. Remove the 4 screws and the starter unit.
2. Install in the opposite sequence.
7.3.2 To disassemble the starter unit
WARNING: Use protective glasses. The recoil
spring can eject from the starter pulley and
cause injury.
1. Remove the starter unit. Refer to
install the starter unit on page 14.
2. Pull out the starter rope approximately 30 cm and
put the starter rope into the notch in the starter
pulley. Hold the starter pulley with your thumb.
3. Decrease the pressure of your thumb. Let the starter
pulley rotate clockwise slowly to decrease the
tension in the recoil spring.
14 - Repair instructions
1351 - 002 - 25.11.2020
Содержание CHTZ60
Страница 1: ...Workshop manual CHTZ60 English 1351 002 25 11 2020...
Страница 7: ...T27 6 8 Nm T27 6 9 Nm 10 15 Nm 8 mm 6 9 Nm T27 4 6 Nm T27 3 5 Nm 1351 002 25 11 2020 Servicing data 7...
Страница 51: ...1351 002 25 11 2020 Technical data 51...
Страница 52: ...www redmax com 114 19 79 26 2020 12 01...