www.redlanddentalproducts.com
6
ABOUT DISINFECTION
DISINFECTION OF THE FOLDING ARM/SELF-SUPPORTING ARM
DISINFECTION OF THE CASE
I
Disinfection of suction nozzle: spray disinfection water, alcohol or other liquid with
disinfection function to disinfect the surface.
II
Disinfection of the Self – supporting arm, after daily use, please turn on the machine con
tinuously for 30 second and then turn it off. At this time, the droplet, liquid, and dust on the
support arm can be minimized to the greatest extent.
III
When disinfecting regularly, please hold the support arm by hands, hold down the
connection between the support arm and the machine, and pull the support arm out of the
vertical direction of the device. Afterward, twist the connection of the support arm clockwise
and disassemble it.
Separate each section of the support arm, sterilize the inner tube wall, and then assemble it
after more than 2 hours.
IV
Disinfect the connection between the support arm and the machine; note that after
spraying the disinfection liquid to the connecting part, Wipe it as soon as possible and wait for
1 hour.
I
Disinfection of filter element:
The filter element is recommended to be replaced regularly.
It is strictly forbidden to wash and sterilize the filter element other than the primary effect
water filter element and then use it again.
II
About the disinfection inside the chassis:
Take out all the filter element, and then spray disinfection water or other disinfection supplies
into chassis.
After spraying , use a soft fabric to clean the inside, and just leave the case for more than 2
hours without closing the case
.
III
Regarding the disinfection of the disinfection layer:
The disinfection layer needs to open the bottom cover, usually the disinfection compartment
does not need to be disinfected, and a simple disinfection process can be performed when
replacing the UV lamp.
#It is forbidden to use organic solvents to sterilize the equipment.
During the sterilization process, please bring a mask to prevent dust.
