background image

Note! If need to make changes later on in your set-

tings (mobile numbers or personal info), you should 

ALWAYS click Save on the page where you have 

made your changes. After that, go to flap 6 (Send), 

click on Clear History and after that on the Send 

button. 

7. Now the SBX-3 is ready to use. Call the SBX-3 

from your mobile phone number defined in EZStart. 

The SBX-3 will deny the call resulting in a busy tone 

or an error message from the operator. You will 

receive an SMS with position and status information 

within a minute.

8. Use your remote control to activate or deactivate 

the alarm. For more information – see operating 

manual.

 

1 White

Check list

 

The siren beeps three times when you activate 

the alarm with the remote control.

This warns you the alarm cannot be activated, since 

one of the sensor input is active. 

No SMS is received when you call your SBX-3

Check GSM reception in area

Call again

Check placement of GSM antenna

Check/re-enter settings on website

Is pincode on SIM-card removed?

Caller ID-support must be active

Is voice mail disconnected (some operators   

 

must do it for you)

GPS reception. Is red GPS LED flashing?    

 

Place antenna as freely as possible. Test!

NOTE! The same mobile phone number cannot be 

used for both status SMS and for listening to the mi-

crophone. Two different numbers must be used.

Circuit diagram

Antenna (for remote control)

2 Orange

Not active

3 Yellow

Relay (option)

4 Green

Siren

5 Brown/white

Input. Not active

6 Blue

Door trigger (option),

NO. Positive activation

8 Purple

Sensor1 input. A vibration sensor 

can be connected. (option) NO. 

Negative activation. 3 impulses 

within 6 sec. to trigger alarm. 

9 Grey

Sensor2 input. The magnetic 

contact can be connected. NC. 

Positive activation. (This input 

must be grounded if not used).

11 Brown

Ignition key input. Positive 

activation.

12V

SBX-3

GPS

Microphone

GSM-antenna

12 Black

Built-in spare battery. Ground

10 Red

7 Black

Fuse 

 

I/O specifications:

Main battery: 12 V, 
24V 

or 10V -30V.

Input 6, 11: Max 30V
Output 3: Max 300 mA

Main battery

Axtech AB

 

St Jörgens väg 4, S-422 49 Hisings Backa, tel. +46 (0)31-558866, fax. +46 (0)31-558869

e-mail: [email protected], www.axtech.se, www.redknows.com 

Axtech, Quickstart SBX-3, 

Отзывы: