KEY PARTS DIAGRAM
No.
Description
No.
Description
1
Magazine
4
Trigger
2
Gun Body
5
Air inlet plug
3
Cylinder Cap
IMPORTANT INFORMATION
Compatible compressors
GUIDELINES FOR PROPER USE AND OPERATION
Be sure to use a proper air compressor with air powered tools. The compressor should be able to supply a minimal
air delivery of
6
.
36SC
F
M @ 90PSI
to ensure the compressor can run continuously with the air nailer.
General use
This Brad nailer drives 18-gauge Brad nail 5/8" to 2"(15 to 50mm) long, If feature a die-cast aluminum housing and a
comfortable handle for optimal control and comfort, even during extended use. It is well balanced for stability, and
ergonomically designed with a longer handle for ease of operation. It also features a hardened driver blade for
longer life, and economical air consumption with low noise. This air powered Brad nailer is specifically designed for
professional work.
Air
system
•
Always use clean, dry, regulated, compressed air at 4.8 to 7.5 bar(70 to 110psi).
•
Do not exceed the maximum or minimum pressures. Operating the tool at the wrong pressure(too low or too
high) will cause excessive noise or rapid wear of tool.
_A\
WARNING!
ffi
Potential hazard that could result in serious injury or loss of life.
•
Keep hands and other parts of the body away from the tools discharge and working areas when
connecting the air supply. Failure to comply could lead to serious injury or loss of life.
•
It is recommended that a filter-regulator-lubricator is used and located as close to the tool as possible.
•
If a filter-regulator-lubricator in not installed, place up to 6 drops of compressor oil into the inlet plug
before each use.
•
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure
