9 |
P a g e
Remote Control unit
How to Operate the Heater
NOTE:
The heater may emit a slight harmless smoke when first used. This smoke is a normal condition
caused by initial heating of the infrared element. It will occur only briefly and is not harmful.
Un-package heater:
Cut open tape area, fold back flaps and gently turn entire box upside down. Lift
box from Styrofoam packing. Remove Styrofoam, turn upright.
We recommend keeping the
package for off-season storage and any transporting needs.
Position:
Find a level and unobstructed location to place the unpackaged heater.
Plug
in:
Plug the power cord directly into an unused grounded 120 volt 15 amp or higher circuit
receptacle.
Set ON/OFF switch to ON
:
Press down the switch located on the rear of the heater to the ON
position (I). This provides electricity to the unit.
Set POWER to ON
: Press the POWER button on the LCD panel (or remote control) to turn on the
unit. The Actual Temperature will be displayed.
NOTE: The heating function will still not be active. You must press the HEATER on/off button
(see below) to activate the heating function.
NOTE: After pressing the POWER button to ON, the Air Purifier will operate automatically.
