Redback® A 6500A
Programmable Control System
Redback® A 6500A
Programmable Control System
www.redbackaudio.com.au
Redback® Proudly Made In Australia 23
Redback®
Programmable Control System
6.0 SYSTEM WIRING
6.1 RJ45 cabling configuration for connection between the A 6530 or A 6540 series wallplate
Wall Plate and the
A 6505A Serial Hub (586A ‘Straight through’)
Components are connected using “pin to pin” configuration RJ45 data cabling as shown in fig 6.1. When installing ensure
all connections are verified with a LAN cable tester before switching any system component on.
Failure to follow the correct wiring configuration may result in damage to system components.
Fig 6.1
6.2 Serial wiring
RS232 Serial wiring from the Redback® A 6505A Serial Hub to the Redback® A 6510 or the Redback® A 6515
The RS232 control cabling requires only two connections from the output of the A 6505A Serial Hub to the input connec-
tor of the A 6510 or A 6515. The TX pin of the A 6505A is connected to the RX connection of the A 6510 or A 6515, and
the GND terminals are connected together.
RS232 Serial wiring from Third Party Device to Redback® A 6510 or the Redback® A 6515
The RS232 control cabling requires only two connections from the output of the third party device to the input connector
of the A 6510 or A 6515. The TX pin of the output device is connected to the RX connection of the A 6510 or A 6515,
and the GND terminals are connected together.
RS485 Serial wiring from the Redback® A 6505A Serial Hub to the Redback® A 6510 or the Redback® A 6515
The RS485 control cabling requires three connections from the output of the A 6505A Serial Hub to the input connector
of the A 6510 or A 6515. The “A” connection of the A 6505A is connected to the “A” connection of the A 6510 or A
6515, the “B” connection of the A 6505A is connected to the “B” connection of the A 6510 or A 6515 and the GND
terminals are connected together.
RS485 Serial wiring from Third Party Device to Redback® A 6510 or the Redback® A 6515
The RS485 control cabling requires three connections from the output of the third party device to the input connector of
the A 6510 or A 6515. The “A” pin of the output device is connected to the “A” connection of the A 6510 or A 6515,
the “B” pin of the output device is connected to the “B” connection of the A 6510 or A 6515, and the GND terminals are
connected together.
7.0 TROUBLE SHOOTING
SYMPTOMS
REMEDIES
A 6530 or A 6540 series wallplate wall plate not powering up
Check Cat5e connection to
A
6505A/07/10/12/14/15
A 6507/6510/A 6512/A 6514 or A 6515 not
Check DIP switches 1-3 on these units are set correctly and/or
accepting serial codes
check wiring
IR transmission not working
Check IR led wiring/check DIP switch 1 on A 6505A
568A
1 RX+
2 RX-
3 TX +
4
5
6 TX-
7
8
Straight Through
(both ends)
Pins Face Upwards
1 TX+
2 TX-
3 RX +
4
5
6 RX-
7
8