WARNING
FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE:
Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through
openings.
POWER SOURCES:
The appliance should be connected to a power supply only of the type described in the operating instructions or as
marked on the appliance.
GROUNDING OR POLARIZATION:
Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.
POWER CORD PROTECTION:
Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon
or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
SERVICING:
To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:
Replace fuse with same type and rating only.
ELECTROMAGNETIC COMPATIBILITY
This unit conforms to the Product Specifications noted on the Declaration of Conformity. Operation is subject to the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.
Operation of this unit within significant electromagnetic fields should be avoided.
Use only shielded interconnecting cables.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK - DO NOT OPEN
There are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all servicing to
qualified personnel. Opening the chassis for any reason will void the manufacturer’s warranty. Do not get the unit wet. If liquid is spilled on
the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage.
Distributed by Altronic Distributors Pty. Ltd. Perth. Western Australia.
Phone: 1300 780 999 Fax: 1300 790 999
Internet: www.altronics.com.au
A 5350 SPECIFICATIONS
INPUT:
Connectors: XLR
Type:
Electronically balanced/unbalanced, RF filtered
Impedance:
Balanced > 50 kohm, unbalanced > 25 kohm
Max Input Level:
+22 dBu typical, balanced or unbalanced
CMRR:
>40 dB, typically > 55 dB at 1 kHz
OUTPUT:
Connectors: XLR
Type:
Impedance-balanced/unbalanced, RF filtered
Impedance:
Balanced 200 ohm, unbalanced 100 ohm
Max Output Level:
>+21 dBu balanced/unbalanced into 2 kohm or greater
PERFORMANCE:
Bandwidth:
20 Hz to 20 kHz, +0/-0.5 dB
Frequency Response:
< 3 Hz to > 90 kHz, +0/-3 dB
Signal-to-Noise:
Ref: +4 dBu, 22 kHz measurement bandwidth
Stereo Mode:
Mono Mode:
Low Output:
> 94 dB
> 94 dB
Mid Output:
> 93 dB
High Output:
> 91 dB
> 91 dB
Dynamic Range:
> 106 dB, unweighted, any output
THD+Noise:
< 0.004% at +4 dBu, 1 kHz
< 0.04% at +20 dBu, 1 kHz
Interchannel Crosstalk:
< -80 dB, 20 Hz to 20 kHz
CROSSOVER FREQUENCIES:
Stereo Mode:
Low/High:
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
Mono Mode:
Low/Mid:
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
Mid/High:
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
Filter Type:
Linkwitz-Riley, 24 dB/octave, state-variable
FUNCTION SWITCHES:
Low Cut:
Activates 40 Hz Butterworth, 12 dB/octave high-pass
filter, one switch per channel.
Phase Invert:
Inverts the phase at the output, one switch per output.
x10:
Multiplies crossover frequency range by 10, one switch per channel.
Mode:
Selects stereo/mono and 2/3/4-way operation.
LF Sum: Selects normal (stereo) or mono-summed low frequency operation.
INDICATORS:
Stereo Operation:
Green LED
Mono Operation:
Yellow LED
Low Cut:
Red LED per channel
x10:
Green LED per channel
Phase Invert:
Red LED per output (3 per channel)
POWER SUPPLY:
Operating Voltage:
240 VAC 50/60 Hz
Power Consumption:
15 Watts
PHYSICAL:
Dimensions:
44 x 483 x 175mm
Weight: 2kg
