background image

INSTALLATION INSTRUCTIONS

Retrofit Installation

Precaution: Locate existing pipes, duct work, and AC wiring prior to cutting any holes.
   1.  Center the cardboard template between adjacent joists. While avoiding all

        wiring, pipes, and duct work, lightly mark the outline with a pencil. 
   2.  Use a keyhole/drywall saw or motorized spiral-cut tool to make a small

        opening to check for wiring, pipes, and duct work.
   3.  Score the outline of the template with a utility knife to prevent chipping. If dealing

        with lath and plaster or thick paneling, drill 1” (2.5 cm) holes in several places

        around the pencil outline. 
   4.  Use a fine-toothed keyhole saw or hacksaw blade with slow strokes to saw

        through and remove the inner surface.

Pre-wire or Pre-construction with mounting bracket

Precaution: Locate existing pipes, duct work, and AC wiring.
   1.  Route the speaker wire to the speaker location avoiding all obstacles.
   2.  REDATOM offers Speaker Rough-In Brackets (RED6KIT & RED8KIT) that can be

        fastened to the adjacent studs. Once the dry wall is installed, the opening is

        cut-out. There are holes molded into the bracket for speaker wire tie-off to keep

        the wire from being lost during construction.
   3.  Make sure the speaker cut-out (hole) doesn’t extend further than ¼” (0.6 cm)

        from the inside of the mounting bracket.

Safety Precaution:

Start by drilling shallow to avoid damage to wiring, pipes and ductwork.

Center the speaker in the cutout. Rotate the frame as needed before tightening
the screws. Tighten the screws equally until the clamps secure the frame.

Do not overtighten.

As the screws are 

tightened the fastener 

will rotate out and 

become snug against 

the drywall.

In-Ceiling Bracket Installation

Attach the speaker wires to the red (+) and 
black (-) speaker terminals. Connect the 
Positive (+) conductor to the red terminal and 
the Negative (-) conductor to the Black 
terminal. Make sure that there are no stray 
strands of wire touching the other conductor 
or terminal.

INPUT

Cut-out

Speaker

Speaker Cable

RED ATOM REDIC6

6.5” Round 2-Way In-Ceiling Speaker

Instruction Manual

Отзывы: