RED PT500-2, Руководство по обслуживанию

Страница: 6 / 62

PT500-2 Service Manual
6
Mode combinations
Mode Function How to access
User Mode For normal use Power on
PC
Mode
Data
Programming
mode Reading and writing
frequency data and other
functions
Receive instructions from
the PC
Test Mode
Used to tune the radio
using the PC. Receive instructions from
the PC
Firmware
Upgrading
Mode Upgrades the software
when new features are
added
Receive instructions from
the PC
User Mode
：
You can enter User Mode (conventional communication mode) by turning on the power
switch. Users in the mode can use the defined function of the radio.
Data programming mode:
Before leaving the factory, the radio has been set in factory. However, due to different
requirements of users, functional parameters of the radio such as working frequency,
channels, CTCSS/DCS and auto scanning, etc. should be set again. Therefore, the company
has specially designed a set of PT500 programming software with friendly interface,
convenient operation and visualized display for setting functional parameters of the radio.
Steps for setting the functional parameters of the interphone by computer are as follows:
1. Install PT500 programming software on the computer.
2. As shown in the figure below, connect the radio to the computer through a special serial
or USB programming cable.
Comput
(RS232 seria
/USB po
Programm
cable
Radio
(Earphone /Program port)
Figure 3-1
3. Turn on the power of the computer.