RED MOTION MOUNT OPERATION GUIDE
COPYRIGHT © 2015 RED.COM, INC
955-0013, REV-K | 9
LENS MOUNT ALIGNMENT
When installing the MOTION MOUNT, ensure that the lens mount is properly aligned. The forward-facing contact
pins differ between the two (2) mounts. RED MOTION MOUNT Ti PL contacts pins are located on the top of the
mount, while RED MOTION MOUNT Ti Canon contact pins are located on the bottom of the mount.
REMOVE A LENS MOUNT
REQUIRED TOOL:
T20 TORX
®
driver
1. Turn off the camera.
2. Attach the camera to a stable platform or position the camera on a clean and level work surface so that the
lens mount screws are accessible.
3. Remove the lens, as well as any modules, cables, or other accessories that might interfere with removing
the lens mount.
4. Loosen and remove the four (4) M4 x 0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using
a T20 TORX driver.
NOTE:
Screw removal may require a large handle T20 TORX driver and additional leverage.
NOTE
: The DSMC Mg PL Mount 2.0 has captive screws that are not removable from the mount.
MOTION MOUNT Ti PL (left),
MOTION MOUNT Ti Canon (right)
Remove the lens mount screws
