RED ROOSTER RRI-BIM15T, Руководство пользователя

Страница: 8 / 11

Adjustment of the shut-off.
​Step 1 – 9. Step 1 = very quick shut-off, step 9 = longer impulsing before shut-off, please adjust according the hardness of the actual
joint (a too quick shut-off will have a negative influence on the accuracy)
Hard joint: 2 – 3 – 4
​Middle hard joint: 4 – 5 – 6
Soft joint: 6 – 7 – 8 – 9
Push the button for 2 seconds until the number starts blinking.
​Set the requested number.
​Wait 5 seconds until the number stops blinking or pull the trigger.
Locking the shut-off setting:
Remove the battery.
Push the trigger and L/R switch simultaneously and place the battery, hold the trigger and L/R switch until the tool starts beeping (5
seconds) and release the fingers from the trigger and L/R switch during this beeping.​
​De-locking the shut-off setting: same procedure.
Locking the left rotation:
Remove the battery.
Push the L/R switch and place the battery, hold the L/R switch until the tool starts beeping (+/- 10 seconds) and release the L/R switch
during this beeping.​
De-locking the left rotation: same procedure.
LED indicator and beeper on the tool shows the following status:
Status of the LED indicator and beeper ​
Status of the tool
​
Action to be taken
​Light up in red, yellow and green together for one
second.
A long beep for one second. ​
The tool is OK to use
​-
​
Light up in red for one
second.
A long beep for one second.
​
The preset torque is not reached, operator
released the trigger before shut-off.
​
The screwing fastener must be
performed again. Operator to hold
the trigger until the tool shuts-off
​
Light up in green.
​
The preset torque is reached and the tightening is
OK.
​-
Blinks in yellow for five times.
Five short beeps The battery power becomes low Replace the battery with a fully
charged one
Light up in yellow for five seconds.
A long beep for five seconds ​The battery power is used up, the tools
stops immediatly. ​Replace the battery with a fully
charged one
​Yellow light & green light are blinking at the same
time ​The tool is in reverse operation ​-
Maintenance:
Check the tool regularly for loose bolts/screws or parts.
In case of power loss: Have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
In case of disposal of the tool, follow local regulations, so as much as possible can be recycled. Do not throw it in the normal waste bin.
The tool should be maintained regularly to minimize the noise emission and occurring vibration.​
ERROR Mode: Display by LED