RED ROOSTER RRI-BA70S3, Руководство пользователя

Страница: 8 / 11

LED indicator and beeper on the tool shows the following status:
​Status of the LED indicator and
beeper ​Status of the tool ​Action to be taken
​Light up in red, yellow and green
together for one scond.
A long beep for one second. ​The motor is switched on ​-
​Light up in red for one second.
A long beep for one second. ​The preset torque is not reached
(NOK). ​The screwing fastener must be
performed again.
​Light up in red for one second.
A long beep for one second. ​The screw is refastened after
fastening (NOK). ​The screwing fastener must be
performed again.
​Light up in green. ​The preset torque is reached and
the tightening is OK. ​-
​Blinks in yellow for five times.
Five short beeps ​The battery power becomes low ​Replace the battery with a fully
charged one
Light up in yellow for five seconds.
A long beep for five seconds ​The battery power is used up, the
tool stops immediately. ​Replace the battery with a fully
charged one.
​Light up in blue. ​The tool is in reverse operation ​-
​Blinks in red for two times ​The motor is too hot ​Remove the battery and let the
tool cool down, and then reattach
the battery. The tool can work
properly again.
​Blinks in red for three times. ​The motor has failed. ​Send to the service center.
​Blinks in red for four times ​The connector wire has failed. ​Send to the service center.
Left – Right rotation:
For left rotation: push the F/R button, blue light > tool is in left rotation. Push F/R button again for right rotation.
​Automatically switching back from left to right rotation: push the F/R button for 5 seconds until the blue LED blinks once, now the tool
rotates one cycle in left direction and after stopping the tool switches automatic to the right rotation. Deactivating: holding the F/R
button again for 5 seconds until the blue LED blinks once.
RPM setting angle model:
With the "Programmer" the rpm of the motor can be adjusted up to including the RRI-BA35S3, see manual of the Programmer.
Angle head position adjustment:
Loosen the nut of the angle head by using 2 wrenches.
Angle head has 8 positions, mount the angle head in the requested position and take that the positioning pins are in place.
Tighten the nut of the angle head by using 2 wrenches.