ASSEMBLY INSTRUCTIONS
1.
Remove rotary hoe from shipping crate.
Screw the handle bar adjustment crank into the lower handle bar adjuster pin.
Fasten handle bar to rotary hoe using the 1/2" x 3" bolt supplied.
Arrange hoses down handle bar tube and fasten to the tube with tie wraps provided.
Adjust clutch cable by removing all slack in lever.
Check reservoir according to instructions in service information on page eight (8).
Fill engine with fuel and oil according to the engine manual.
Free wheel hubs: Pull one free wheeling pin slightly, using the split ring. Rotate the pin until
the 1/8" diameter roll pin aligns with the slot mounting plate. Allow the pin to slide through
the slot. Repeat for the other wheel. Roll the rotary hoe until each pin drops into a hole in the hub.
The hubs are now locked.
Uncoil the wire for the remote engine on/off switch. Route wire along the clutch cable to the
engine and secure with the cable ties provided. Splice this wire to the kill switch wire on the
engine with the electrical splice provided.
2.
3.
4.
5.
6.
7.
8.
9.
15
PARTS LIST FOR SG-350 DRAWING 2
Item No.
Part No.
Description
Quantity
1
0217-0001
Brake, Hand
1
2
0301-0014
Cable, Hand Brake
1
3
0209-1040
Bolt
2
4
2301-0507
Washer
4
5
1401-0003
Nut
2
6
0209-0840
Bolt
2
7
2301-0505
Washer
4
8
1401-0508
Nut
2
9
0201-0002
Brake, Band Assy
1
10
0217-0002
Brake, Drum Assy
1
11
1604-0035
Pin, Cable
2
12
1913-0077
Spacer
1
13
1401-0008
Nut
2
14
0209-0670
Bolt
1
15
0705-0008
Guide (Rope Start)
1
16
2301-0034
Washer
1
17
1401-0503
Nut
1
18
0214-0106
Bracket
1
You alone know the operational demands and special
conditions affecting the equipment in your situation and
therefore assume the responsibility for developing,
carrying out, and enforcing the safety concepts which
apply to your own operation to effect the greatest safety
for yourself and the people around you.
Commercial Environmental Equipment
™
4