To open the stroller
1. Release the storage latch on the side of the stroller and lift the handle in an upwards motion until it locks in
place. Fig 1.
WARNING! Ensure that all the locking devices are engaged before use.
To attach the bumper bar
2. Insert the ends of the bumper bar in to the slots of the sides of the frame and push inwards until they click in place. Push the buttons
located on the frame joints to release the bumper bar. Fig 2.
To attach the rear wheels
3. Push a washer on to the end of the axle followed by the wheel and another washer. Push the straight edge
of the split pin through the hole in the end of the axle and cover with the hub-cap. Fig 3.
Rear axle/brake assembly
4. Slot the rear legs in to the axle assemble and push down hard until it clicks in place. Make sure the push
pin has popped through the hole. Fig 4.
Front wheel assembly and swivel lock
5. With the swivel lock on the top of the wheel unit, push it on to the front leg until it clicks in place. To lock the wheel in a fixed mode,
ensure the wheel is facing forward and lift the swivel lock upwards. Push it down to revert back to a swivel wheel. Fig 5 + 5a..
To use the brakes
6. Press down on the brake pedal to engage the brakes and lift it back up to release them. Fig 6.
WARNING Apply all the brakes whenever you park the stroller.
To adjust the back rest
7. Squeeze the clip on the back of the seat unit and pull down to select a lower position. To raise the seat,
hold the bottom of the strap and push the clip upwards. Fig 7.
To adjust the calf rest
8. Press the buttons on both sides and raise or lower to desired position. Fig 8.
To adjust the hood
9. Pull the hood forward or backward to desired position. Fig 9.
To use the rain cover
10. Ensure the back part goes through the gap between the handle and hood and fix in place with hook and loop strips and then pull
the front of the cover over the foot rest. Fig 10.
To fold the stroller
11. Engage the brakes, retract the hood and lower the seat to a lie back position. Pull the locks on both sides of the frame towards you
(fig 11a) then lower the handle towards the ground. Secure the frame in a locked position by attaching the locking catch. Fig 11b.
To adjust and secure the harness
Push the buckle prongs in to the buckle housing until they snap into position. Adjust sliders to ensure a snug
fit for your child. After making adjustments to the seat always re adjust the harness. Release the harness by
pressing the button on the buckle housing unit. Fig 12.
WARNING Always use the crotch strap in combination with the waist belt.
WARNING! For babies aged 0 - 6 months the harness must be fed through the lowest holes to prevent risk
of strangulation.
Parts List
1. Frame
2. Front wheel x 1
3. Rear axle/brake unit,
wheels and fitting kit
4. Bumper bar
5. Rain cover
2
3
4
1
5
