3/16/2020
www.reddevilsnowblowers.com | Red Devil Snow Blowers
Page | 6
Red Devil Snow Blowers is a registered trademark of Lankota Group.
Skid Steer Wiring Installation
-
Rocker Switches
Figure 9
Use these instructions if the 8
-
Pin and 14
-
Pin connectors will not work on your skid loader.
The switches may be located in the provided switch plates, or in available switch knockouts in the skid steer. The below instructions show a
typical skid steer installation. Location details will vary between makes and models.
1.
Insert two momentary switches (REDRS1093) into the upper cab panel (Figures 9 & 10).
2.
Attach the one of the short red wires from RED56WIR
-
4 to the middle post of a momentary switches. (The momentary switches are identical.)
Then attach the blue wire and the brown wire of harness RED56WIR
-
3 to the same switch, one on either side of the red wire (Figure 11). This will
be your chute rotation motor switch.
3.
Attach the other short red wire from RED56WIR
-
4 to the middle post of the second momentary switch. Then attach the green wire and yellow
wire of harness RED56WIR
-
3 to the switch, one on each side of the red wire (Figure 12). This will be your deflector control switch.
4.
Connect the free end of the Red wire (RED56WIR
-
4) to the power wire on the skid loader and the free end of the Black wire of harness
(RED56WIR
-
3) to a ground wire on the skid loader (Figure 13).
Figure 10
