LED 110V Tripod
Instructions p.1
Red Arrow Trading
Elsworth House, Herries Road South
Sheffield, S6 1QS
T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
This installation must be carried out by an electrician.
Please read these instructions carefully before installation.
Leave a copy for the user/maintenance engineer for future reference.
For models: LEDLF0207
IMPORTANT SAFETY INFORMATION
•
This is a mains powered product. Only authorised and
qualified personnel can install it. Before installation or
maintenance, keep it isolated from general power supply.
Specification
•
110V LED Tripod
•
Class I (must be earthed)
•
Wattage: 2 x 30W
•
Material: Aluminium
•
Lamp type (included): 2 x 30W Epistar LED
•
Plug: 1 x 16A, 110V, IP44.
•
Supply voltage: 85-265V
•
IP Rating: IP65
•
Cable: 3m 1.5mm²
•
Finish: Black & Yellow
ASSEMBLY
•
The tripod stand is supplied assembled. To attach the
floodlights you must erect the stand.
•
To open the legs push the spring pin upwards and, at the
same time, pivot the leg down. Release the spring pin whilst
pivoting the leg and the pin will locate into one slot.
•
To alter the stand height twist the locks anti-clockwise to
release, slide the tubes to desired height and tighten the
twist locks clockwise.
•
Attach the floodlights to the crossbar by securing with the
screw knob nut & bolt assemblies through the centre hole on
the brackets of each floodlight.
•
Unscrew the centre knob. The bracket on the central wiring
block should be situated between the top of the stand and the
crossbar. Re-insert the centre screw knob through the central
hole of the crossbar and the hole in the central wiring block
bracket.
•
The crossbar can be swivelled, if required, by loosening the
knob, moving the crossbar, and retightening the knob.
The stand has an integral cable tidy for safe storage of the
mains cable when not in use.
•
To adjust the floodlights angle, loosen the screws located on
either side of the bracket, until the desired angle is achieved,
then re-tighten.
•
Check the floodlight is secure and that the stand is stable
and has a firm footing. Ensure cable is not catching on any
sharp objects and that the mains plug connection is
adequately protected against rain or moisture. Your
worklight is now ready for use.
