Recsea WHC-G1XMkIII, Руководство пользователя

Страница: 6 / 12

※
The housing Front Dail, Mode Dial, Exposure Compensation Dial, and Control Dial are
designed to turn these camera dials back and forth via friction from the O-ring that comes
in contact with them inside the housing. Should the dials begin to slip, use a clean soft dry
cloth to wipe away any oil and other contaminates that may cause the loss of friction from
the O-rings and camera dials.
※
Use Strobe Mask-External Strobe Connection Mount as required for attaching external
flash cables.
※
Open camera flash prior to installing camera.
※
Attach Diffuser using the grooves provided on the Lens Port as shown above.
OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly
placed in the Secure-Latch Groove attached to the main housing body. Push into the locked
position. Double check to make sure it is firmly locked into place.
INSTALLING CAMERA
CAUTION! Before using, please be sure to test the housing (without camera) in a bucket of
freshwater. After use in salt water, rinse thoroughly in a bucket of fresh water without fail,
pressing all buttons several times to flush out salt deposits and other contaminants. Allowing
saltwater and contaminants to dry on housing can damage functions and O-rings. Clean with
fresh water only, using a soft, dry cloth to wipe away water.
※
Please perform proper housing and port O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Remove camera lens cap, strap, and any other option(s) that might cause an obstruction.
2. Check camera settings, battery is charged and media storage capacity is sufficient.
3. Make sure camera flash is open.
4. Slowly and carefully install camera making sure the is camera properly pushed forward
and seated so the internal bezel of the Continuous Control Ring Dial grips the camer's
dial. If the camera is not installed correctly, buttons, dials, and levers may not function
properly.
5. After performing O-ring Maintenance, carefully close back cover making sure nothing is
caught between the Secure-Latch and housing. Push Secure-Latch into the closed
position making sure the Lock Lever is in the locked position. Double check to make sure
the Secure-Latch is securely locked into place.
6. TEST ALL FUNCTIONS, paying special attetion to the rear Control Dial push-button
funtions. If the dial push-buttons does NOT function properly, remove camera from
housing, reinstall and test again. If the camera is not installed correctly, buttons, dials,
and levers may not work properly.
REMOVING CAMERA
CAUTION! After use in water, water will remain in gaps between housing, back cover and
Secure-Latch. Due to pressurization after submersion, water on and around the closure may
be sucked in at time of opening. Before opening wipe all excess water from housing with a
soft dry towel to prevent water from falling on camera.
1. Press Lock Lever while pulling Secure-Latch away from housing main body. Open back
cover.
2. Tip Housing backwards, gently sliding camera out of housing.
4.