42
20. RPLB24-48 Specifications
21. RPLB24-48 Assembly
The RPLB 24-48 Lathe bench can be adjusted to suit the CL3-CAM and CL4-CAM Record Power lathes. It is also possible to fit the DML36SH-CAM Record
Power lathe, providing alternative holes are drilled. Other lathes may be accommodated by drilling extra holes in the side rails or by mounting a wooden top
with suitable holes for bolting the lathe down.
Length (36” Lathe)
1664 mm
Width
547 mm
Height
800 mm
Weight
45 kg
IMPORTANT: Unless otherwise instructed, do not fully tighten
any of the fixing bolts until all of the assembly instructions have
been completed.
Before assembling the lathe stand, take time to correctly
identify the upper and lower side rails. They have differing
lengths and can only be used in the intended positions. The
lathe stand cannot be assembled successfully if the wrong size
rails are used in the wrong places. Please see section 19 for full
details of sizes.
1. Assemble upper side rail (
6
) into (
5
) and lining up the relevant holes to
suit the required lathe length (36”). Screw (
14
) 2 off into the nuts on (
5
) and
locate into the holes in (
6
). Fully tighten.
2. Assemble the lower side rails in the same way. Slide (
8
) into (
7
) and locate
bolts (
14
) through the nuts on (
7
) and into the relevant holes in (
8
). Fully
tighten.
3. Bolt the ends of rails (
5
and
7
) to the leg (
1
) using fastenings (
13
,
11
and
12
). Please note: all nuts and washers should be on the inside of the bench.
4. Bolt the ends of rails (
6
and
8
) to leg (
2
) using fastenings (
9
,
11
and
12
).
5. Repeat for the remainder of the rails (
5
,
6
,
7
and
8
). Then legs (
1
and
2
).
You now have 2 leg sub-assemblies.
i
Kg
Fig.21.1
Fig.21.2
6. Assemble the end rails (
4
and
17
) to the legs (
1
and
2
) with fasteners
(
9
,
11
and
12
). Ensure that the widest bolt hole centres in the end rail are
nearest the bottom of the rail.
Содержание CL3-CAM
Страница 20: ...20 6 Assembly Instructions cont Fig 6 46 Fig 6 47 ...
Страница 35: ...35 13 Spare Part Identification VSLK for CL4 CAM only ...
Страница 46: ...46 ...
Страница 47: ...47 ...
