Recognition Systems HandKey II, Инструкция по установке и эксплуатации

Страница: 39 / 134

HandKey II Installation and Operation Manual
Revision 2.0 Page 39
The Hand Reader automatically assigns Authority Level 0 to each ID number enrolled.
Until a user has been assigned to Authority Level 5, every user with Authority Level 0
can access every menu. This is done to ensure that the first person enrolled is able to
access all the menus to perform all the programming required to support the Hand
Reader. Once a user has been assigned to Authority Level 5, all other user authority
levels are applied as per the list above.
The first person enrolled should be designated the System Administrator and should
change his/her Authority Level to 5. This protects the integrity of the system by
enacting the Authority Level rules described in the list above. Recognition Systems
strongly recommends assigning at least two users to Authority Level 5 to ensure that
more than one person has the authority to access all menus and all commands.
Programming Order
When setting up Hand Reader operations there is a general programming/operations
order that should be followed.
Design an ID Numbering System – Define the format for user ID assignments. A
properly designed ID numbering system makes the Hand Reader easier and faster
to use.
Enter a Command Menu – Enter a Command Menu and begin Hand Reader
programming per the commands in that menu.
Enroll all Supervisory Staff – Enroll yourself and the supervisors who will have
responsibility for Hand Reader management. This is done through the Enrollment
Menu.
Set Supervisory Staff Authority Levels – Assign Authority Levels to the supervisors
with specific Hand Reader management responsibilities. This is done through the
Security Menu.
Set Reader Site Parameters – Set the reader’s Operating Parameters to meet site
specific needs and usage. This is done through the Setup Menu.
Train and Enroll Users – Train each user regarding Hand Reader usage and then Enroll
each user. This is done through the Enrollment Menu.
System Management and Maintenance
Once a Hand Reader network is in operation the following commands are used to
manage and maintain the Hand Reader network.
Set Reader Operating Thresholds – Set the Reject and Number-of-Tries Hand Reader
operating thresholds to meet the site’s security requirements. This is done through
the Security Menu.
System Management – Backup or Restore Hand Reader data and List the Users
authorized to use a Hand Reader. This is done through the Management Menu.
System Maintenance – Calibrate the Hand Reader, display Hand Reader Status, and
display Network Status. This is done through the Service Menu.
NOTE