Mini SD card mobile DVR M602 user manual
starting but not login, the device will display four-picture, after 20S, it will
display the screen set up in “Preview”.
ACC Delay:
Used to set when to shutdown the system after setting ACC staling. The value
between [0--255] can be set (unit is minute). When set 255, even the state is
ignition, the system will not shutdown.
Startup Mode:
There are ACC and timing options. The startup mode is default to ACC.
When select ACC starting and shutdown, the system can be started once
receiving the ignition signal; when select timing starting and shutdown, you
need to set the time of starting and shutdown in “Timing”. The system will
start only when the time set up arrives, and there is nothing related to the
ACC signal. You can also use the
【
POWER
】
key on the remote control to
start the device.
3.8.2.2 Recoding Setting
Used to configure recording parameters which are explained as follows:
Channel:
Choose the number of the target channel to be set up.
Type:
There are main stream and sub stream for selection. Main stream is mainly used for
recording setting while sub stream is mainly used for compressing bit stream during
network transmission in order to lighten the hardware burden.
Stream:
There are two options: A/V (refer to the data stream generated by compressing the
video signal and audio signal) and V (the data stream generated by compressing the
single video signal)
CBR/VBR:
There are
VBR and CBR options. When set VBR, you can configure the image
quality.
BitRate:
There are 128Kbps, 256Kbps, 512Kbps, 1Mbps (unit is bps) options. The specific
limit size of the bit rate will be adjusted according to the scene and the camera condition and
the requirement on the image quality.
FrameRate:
Full frame rate (PAL 25f/s, NTSC 30f/s), 20f/s, 15f/s, 10f/s, 5f/s, 2f/s, 1f/s.
Resolution:
When set VBR, you can set the image quality.
CopyTo:
Used to copy the parameters of this channel to other channel so as to configure
quickly.
