recharge health FlexBeam, Инструкция по эксплуатации

Страница: 7 / 13

13 12
Select the Program
Turn FlexBeam® on and select the program:
Using Your FlexBeam®
Position FlexBeam®
Place FlexBeam® on the desired location, securing with the
supplied bands if needed. Always use your FlexBeam® directly
on the skin, removing any clothing. Light does not penetrate
clothing and treatment will be ineffective. You can attach
FlexBeam® to the body using the supplied bands. The
instructions of how to use these bands can be found on-line
and in your quick start guide.
Important: Never stare at the LEDs or use FlexBeam® within
30cm of the eyes. Powerful invisible infrared light emitted.
1
Each program is timed as a 10-minute cycle. After completion,
your FlexBeam® will make a sound and pause to allow for another
program selection. If not in use, it will automatically switch OFF.
1. Skin and Surface
Mostly red light.
2. Muscles and Tissue
Combined Red/Infrared
light to reach depths
below the skin.
3. Deep Tissue and Joints
Powerful infrared light to
penetrate deeper inside
the body.
Before you apply FlexBeam® for the first time make sure it’s fully
charged. Insert the power cord provided into the power port
located on the interface module of your FlexBeam®. It will take
approximately 2 hours to charge.
2
When to Use FlexBeam®
For best results, use once daily, or up to 4 times a day on
different areas of the body. FlexBeam® is designed to deliver
an optimal dose of light for each program cycle to trigger your
body’s positive response.
When applying FlexBeam® in one part of the body: apply only
one cycle (usually this is enough to deliver the optimal dose of
stimulation). Do not overuse.
3