2
3
Maintenance
Care
All plastic parts may be easily cleaned using a mild commercially available plastic cleanser.
Observe instructions for use. For the steel tubing it is sufficient in most cases to wipe it with a
damp cloth, and then wipe dry. For the chrome foot pedestal, wiping with a damp cloth and
wiping dry is also sufficient.
Advisory! Do not use solvent containing or oily cleaner!
Maintenance
The Stand-Up Aid is characterised by a long service lifetime and high reliability. Should it fail
to properly function because, for example the gas filled piston no longer operates, do not
attempt to repair it yourself. Contact the nearest specialised dealer or care provider.
Inadequate or negligent care and maintenance leads to limitations or annulment of product
liability by the Manufacturer.
Allow your Stand-up Aid to be checked over by specialised dealer once a year!
For safety reasons only original spare parts may be used.
Safety Instructions!
Be sure the maximum allowable weight for the Stand-Up Aid is not exceeded!
Before each use of the Stand-Up Aid, carefully check it over for damage. If you have any
doubts, then do not use the Stand-Up Aid. Contact your specialised dealer.
DANGER of falling!
Do not bend over too far forwards when sitting on the Stand-Up Aid.
DANGER of slipping!
Always use CAUTION when using the Stand-Up Aid with wheels
on moist surfaces, loose carpeting or rugs.
Always maintain a stable position when using the Stand-Up Aid.
If unused for an extended time period, have the Stand-Up Aid inspected by a specialist
before using again.
Intended Use / User Advisory
The Stand-Up Aids
are designed for persons with limited standing ability and serve to
increase their ability to stand up, and to relieve the pa
tient’s legs and spine.
Further they are a help for patients being fitted with orthoses.
For individual seating requirements, the seat height and the seat angle are adjustable.
The 5-arm pedestal provides stability. The seat may be washed.
Have your specialised dealer or care provider to advise you on using the Stand-Up Aid
and its adjustment for proper function!
Assembly Instructions
The product is delivered in the package not fully assembled. Before using it for the first time,
the following assembly steps must be performed:
1. Remove the pre-assembled components (seat, gas piston, and pedestal) from the
packaging.
2. Insert the gas piston in the pedestal. Next put the seat adapter on the gas piston.
3. Next press with force the seat onto the gas piston so that the two parts are firmly wedged
together.
4. Carefully check the 2 pieces to be sure they are properly fitted together.
Repeat step 3 if necessary.
First-time Use
They Stand-Up Aid is now ready to use. When using the Stand-Up Aid for the first time, the
following points must be observed:
Height Adjustment
By activating the release lever of the gas-filled piston, you can adjust the height of the
Stand-Up Aid.
Sit down on the Stand-Up Aid and pull the lever up.
-
Version: STAND UP-Standard
Lever at back of seat
-
Version: STAND UP-Plus, SIT UP-Mini and Maxi
Lever left of seat
The Stand-Up Aid now lifts up to its uppermost position. By loading the seat accordingly, the
desired height can be regulated.
By releasing the lever, the gas piston blocks by itself.
Adjusting the Seat Angle
Version: STAND UP Standard
Using this wrench, loosen the M8 screw at the seat tube and select the desired seat angle.
After selecting the angle, securely tighten the M8 screw.
Version. STAND UP-Plus, SIT UP-Mini, Maxi
Under the seat there is to the right a lever for adjusting the seat angle.
By lifting the lever up, it is possible to press the seat to the desired angle.
After releasing the lever, the seat locks into position by itself.
