Rebir EM1-950E-2, Руководство пользователя

Страница: 14 / 19

Leave the tool at room temperature for 2-3 hours before use after transportation
in cold weather.
If condensation forms on the tool do not operate until the tool is completely dry.
Always clean the tool after use. Check if the ventilation slots are clean.
Commutator service
In the course of time the commutator becomes oxidized. This will result in loss of tool per-
formance (the brushes are sparking at the commutator) and can lead to motor rotor dam-
age. For commutator service please contact an authorized service centre or the factory.
Carbon brush service
The carbon brushes should be serviced after every 50 hours of operation. For brush
service please contact an authorized service centtre or the factory.
Lubricating
The lubricating grease should be renewed after every 50 operating hours.Please
contact an authorized service centre or the factory.
THE PROCEDURE OF SUBMISSION OF CONSUMER CLAIMS
The consumer has the right to file claims against the manufacturer for the non-con-
formity of products with the terms of the agreement within the term from the moment
of purchase of the product specified in European Parliament and Council Directive
99/44/EC dated May 25, 1999.
For service please contact the manufacturer or an authorized service centre directly.
ENVIRONMENTAL PROTECTION
Do dispose power tools as unsorted municipal waste!
In conformity with European Directive 2002/96/EC on waste of electrical
and electronic equipment, electric / electronic tools should be collected
separately and recycled using environment friendly methods.
When service life of the power tool is over the tool owner can return it for
further recycling and regeneration to REBIR service centre or to the dealer.
The tool comprises electronic control. Plumbiferous solder is used in wiring lay-out
of this electronic control.
The tool has the ON/OFF switch with electronic control. Plumbiferous solder is used in it.
All plastic components of the power tool are labelled for sorting and categorized recycling.
NOISE / VIBRATION INFORMATION
Measured values are determined according to EN 60745.
For EM1-950E-2 the sound pressure is 99 dB(A). Sound power level is 112 dB(A).
Due the noise level it is recommended to wear ear protection! Typical level of hand-
arm vibration does not exceed 2,5 m/s 2 .
For EM2-1500E-2 the sound pressure is 95 dB(A). Sound power level is 108 dB(A).
Due the noise level it is recommended to wear ear protection! Typical value of
hand-arm vibration does not exceed 2,5 m/s
2
.
DECLARATION OF CONFORMITY
We declare under our own responsibility that this product is in corfomity with the fol-
lowing Directives: 98/37EC, 89/336/EEC, 73/23/EEC.
We also certify that the product conforms to the following standarts:
EN 60745-1:2003, EN 60745-2-1:2003, EN 55014, EN 61000-3-2, EN 61000-3-3.
The Joint-Stock Company "REBIR"
Board Chairman Assistant for Certification E. Sinicin
The Operation Instructions may or may not reflect the latest tool design. The
manufacturer reserves the right to modify the tool at any time.
- 15 -
EM2 07.201
1