Rear view safety RVS-718F150, Руководство по установке и инструкция к продукту

Страница: 9 / 24

9
Reverse With Confidence
™
Installation Guide
Mirror
The mirror monitor replaces the existing car mirror. Carefully remove the
mirror off the “pin”. Slide the replacement mirror onto the pin and se-
cure it with the screw provided (already in the screw hole). There are
many methods to remove the original rear-view mirror, however, please
don’t force the mirror off the bracket.
The manufacturer will not be responsible for damage caused to your car
by wrong installation of the mirror. Figure 1.1
Camera & Cable
When installing the camera at the rear of the vehicle, remove the exist-
ing tailgate handle and replace with the tundra tailgate handle.
Be sure to position the cable properly. The aviation camera cable uses
aircraft grade connectors which means the camera cable can be ex-
posed to all weather elements. Do not run the cable over sharp edges,
do not kink the cable and keep away from HOT and rotating parts.
Fasten all cables and secure all excess cable. Connect camera to the
camera extension cable which runs inside the vehicle. Attach camera to
the center of the license plate are using the screws provided and adjust
the angle. Figure 1.2
Wiring
After connecting the camera to the "camera cable" the camera should
be plugged into AV2 input. Connect the RED 12V power wire to a an