RTL8812AEBT Combo module User Manual
8
Rev.1.0
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of
the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
(v) Dynamic Frequency Selection (DFS) for devices operating in the bands 5250- 5350 MHz,
5470-5600 MHz and 5650-5725 MHz
French translation:
Avertissement:
Le guide d
’
utilisation des dispositifs pour r
é
seaux locaux doit inclure des instructions pr
é
cises sur les
restrictions susmentionn
é
es, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont r
é
serv
é
s uniquement pour une utilisation
à
l
’
int
é
rieur afin de r
é
duire les risques de brouillage pr
é
judiciable aux syst
è
mes de satellites mobiles utilisant
les m
ê
mes canaux;
(ii) le gain maximal d
’
antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et 5 470-5 725
MHz doit se conformer
à
la limite de p.i.r.e.;
(iii) le gain maximal d
’
antenne permis (pour les dispositifs utilisant la bande 5 725-5 825 MHz) doit se
conformer
à
la limite de p.i.r.e. sp
é
cifi
é
e pour l
’
exploitation point
à
point et non point
à
point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi
ê
tre avis
é
s que les utilisateurs de radars de haute puissance sont
d
é
sign
é
s utilisateurs principaux (c.-
à
-d., qu
’
ils ont la priorit
é
) pour les bandes 5 250-5 350 MHz et 5 650-5
850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
(v) S
é
lection dynamique de fr
é
quences (DFS) pour les dispositifs fonctionnant dans les bandes 5250-5350
MHz, 5470-5600 MHz et 5650-5725 MHz.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) This device and its antenna(s) must not be co-located with any other transmitters except in accordance
with IC multi-transmitter product procedures. Referring to the multi-transmitter policy,
multiple-transmitter(s) and module(s) can be operated simultaneously without reassessment permissive
change.
3) For all products market in Canada, OEM has to limit the operation channels in CH1 to CH11 for 2.4G
band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user
regarding to Regulatory Domain change.
As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed.