Robert H Peterson Co. Model: VR-2A
9-9-20 Page 1
MODEL
:
VR-2A
INSTALLATION AND OPERATING INSTRUCTIONS
MULTI-FUNCTION WIRELESS REMOTE CONTROL SYSTEM
FOR OPERATING SERVO MOTOR VALVE, MANUALLY AND WITH A THERMOSTAT FUNCTION
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas
heating appliances. The system operates on radio frequencies (RF) within a 20-foot range using non-directional signals.
The system operates on one of 1,048,576 security codes that are programmed into the transmitter at the factory; the
remote receiver's code must be matched to that of the transmitter prior to initial use
.
TRANSMITTER
ON/HI
MODE
LO/OFF
BUTTON
WALL CLIP
SLOT
BATTERY
COMPARTMENT
K
C
A
B
T
N
O
R
F
LO/OFF
SET
ON/HI
BUTTON
MODE
BUTTON
SET
BUTTON
This remote control SYSTEM offers the user a battery-operated
remote control to power up to a 6 VDC servo motor or solenoid such
as those used with gas valves used in some heater rated gas logs,
JDV¿UHSODFHVDQGRWKHUJDVKHDWLQJDSSOLDQFHV
The servo motor or solenoid circuit uses the battery power from
the receiver to operate a servo motor or solenoid. The circuit has
reversing polarity software which reverses the positive (+) and
negative (-) output of the receiver's battery power to drive the servo
motor forward/backward. (HI/LO FLAME) The SYSTEM is controlled
by the remote transmitter.
The transmitter operates with two (2) 1.5V AAA batteries.
It is recommended that ALKALINE batteries always be used for
longer battery life and maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter batteries
into the battery compartment. (Use caution that batteries are
installed in the proper direction)
ON/HI
MODE
LO/OFF
SET
1
2
3
4
KEY SETTINGS
•
ON/HI
- Operates unit to ON position, Manually operated servo HI.
•
LO/OFF
- Operates unit to OFF position, manually operated servo LO.
•
MODE
- Changes unit from manual mode to thermo mode.
•
SET
- Sets temperature in thermo mode.
NOTE:
7KLVSURGXFWLVGHVLJQHGIRUXVHZLWKDQDWWHQGHGKHDUWKDSSOLDQFHRU¿UHIHDWXUH$GXOWVPXVWEHSUHVHQWZKHQWKH&RQ
-
WURO6\VWHPLVRSHUDWLQJ'2127SURJUDPRUWKHUPRVWDWLFDOO\VHWWKLV&RQWUROWRRSHUDWHDKHDUWKDSSOLDQFHRU¿UHIHDWXUHZKHQ
$GXOWVDUHQRWSK\VLFDOO\SUHVHQW)XUWKHUPRUH'2127OHDYHWKHKHDUWKDSSOLDQFHRU¿UHIHDWXUHEXUQLQJXQDWWHQGHGLWPD\
FDXVHGDPDJHRUVHULRXVLQMXU\,IDQ$GXOWLVJRLQJWREHDZD\IURPWKHKHDUWKDSSOLDQFHRU¿UHIHDWXUHIRUDQ\OHQJWKRIWLPH
then the handheld/wall mount, receiver/control module and application should be in the “OFF” position.
f i r e - p a r t s . c o m
