13
LIGHTING INSTRUCTIONS
HI
OFF
LIGHT
LOW
Control Knob
PUSH
IN
1. Read and understand all operating instructions bef
ore lighting.
2. Burner control knob must be in the OFF position.
3. Connect propane (LP) cylinder (see above pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button
6. While holding the igniter button with one hand, use
your other hand to push and turn the control knob
to the LIGHT position to light the burner.
7. Keep Burner Control Knob pressed in for 15-30 seconds after ignition.
8. If ignition does not occur in 30 seconds, turn control knob to the OFF position and turn
gas off at the source, wait 5 minutes until gas has cleared and repeat lighting procedure.
Please refer to the trouble shooting pages for
additional support, beginning on page 17.
Using the Ignitor
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
9. After lighting, rotate the Burner Control Knob counter clockwise to LOW setting.
10. Adjust the flame to the desired height with the
control knob.
WARNING
If burner flame goes out during operation,
immediately turn the control knob OFF and let the
gas clear a minimum of 5 minutes before attempting
to re-light the fireplace.
Observe flame, make sure all burner ports are lit. Flame height should be no higher than
13 inches tall.
!
!
8-13”
20.3 - 30.5 cm
1.
Wearing heat-resistant gloves, position the burning
long match or extended lighter near the side of
the burner. DO NOT lean over the fire table while
lighting.
2.
Turn control knob counterclockwise to LIGHT.
3.
Remove long match/extended lighter.
4.
After lighting, rotate the burner control knob counter
clockwise to LOW setting. Observe flame; make sure
all burner ports are lit.
5.
Adjust the flame to the desired height with the
control knob.
6.
Replace the battery as soon as possible.
If battery is dead you may TEMPORARILY use
a long match or extended butane lighter
If doing so:
