Real Flame ELEMENT 1800 DOUBLE SIDED, Инструкция по установке и эксплуатации, Страница: 57 / 60

57
INJECTOR AND PILOT REMOVAL INSTRUCTIONS
(continued)
BURNER REFITMENT
1. Carefully place burner into firebox, supporting LH end of the burner.
2. Tighten gas pipe connection to the end of the burner. Burner can now be lowered fully into the
firebox.
3. Refit burner retaining screws (2 off).
4. Refit Media support tray.
5. Replace media as per media fitment instructions.
6. Refit door. Check door seal is sitting correctly. Hang door onto firebox. Fit screws to seal.
DO NOT OVERTIGHTEN SCREWS – Hand tight is sufficient for door to seal.
7. Fit manometer to appliance.
8. Start appliance and check for gas leaks in lower area and in
firebox.
9. Adjust high and low burner pressures to the dataplate. (The
appliance must operate for 3minutes before high pressure
setting can be obtained.)
Max pressure adjustment nut
Min pressure adjustment screw
10. Check appliance for correct flame operation, Check pilot
flame, Check main burner is not smothered and flames are
even along burner with correct colour and not excessively
yellow or sooty. (Note: it takes up to 10minutes of operation
for the flame to achieve full colour.)
11. Remove manometer and tighten test point.
Check test point for gas leaks.
12. Turn appliance off.
13. Refit door trim