14
off the water supply, Pull the trigger to release
water pressure.
2. Lock the safety lock on the trigger handle by pushing on
the safety lock until it clicks into the slot.
3. Pulling the quick-connect collar backwards, at the same
time, snap the desired nozzle onto the quick-connect
collar (Fig 20).
4. To disconnect a nozzle from the spray wand once the
cleaning job is complete:
5. Turn off the pressure washer and remove the water
bucket/shut off the water supply. Pull the trigger to release
water pressure.
6. Lock the safety lock on the trigger handle bu pushing on
the safety lock until it clicks into the slot.
7. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
9.
WARNING!
Do not make changes to the nozzle
while the trigger is engaged. Doing so could result in damage to
the pressure washer or injury to the user.
Working with Detergents
When cleaning with the pressure washer, some cleaning
tasks can be solved with water alone ,but for most tasks
cleaning with detergent allows for more effective dirt
removal.
WARNING!
Use only detergents specifically
designed for use with pressure washers.
DO NOT USE
household detergents, acids, alkaline solutions, bleaches,
solvents, flammable material, or industrial grade solutions.
These could damage the pressure washer. Many detergents
may require mixing prior to use. Prepare the cleaning
solution as instructed on the solution bottle .
Remove the spray wand attachment from the trigger
gun.
Remove the soap dispenser sprayer from the bottle
and fill with mixed detergent. Put the spray back on when
finished (Fig 21).
Take the soap dispenser attachment and insert in to the gun
lance. Soap bottle installing is same as nozzle installing.
4.
Turn on the pressure washer. Pull the trigger to operate the
unit.
CAUTION!
Always test the detergent in an
inconspicuous area before use.
Apply detergent form the bottom to the top of the dry
surface to be cleaned.
NOTE:
Wetting the surface first is not recommended as
it dilutes the detergent and reduces its cleaning ability.
Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry
on the surface.
CAUTION!
Damage may occur to painted surfaces
if the detergent is allowed to dry on the surface. Wash
and rinse a small section at a time. Avoid working on hot
surfaces or in direct sunlight.
CAUTION!
Failure to follow these cleaning
instructions will cause the injection system to become
clogged and inoperable.
Rinsing with the Pressure Washer
Turn off the pressure washer. Remove the bucket or shut
off the water supply.
Pull the trigger to release water pressure .
Lock the safety lock on the trigger handle by pushing on
the safety lock until clicks into the slot.
Remove the soap dispenser attachment by pushing
firmly in while twisting it clockwise to unlock the tabs
and remove from the slots. Pull the attachment out of the
trigger gun.
Attach the spray wand onto the trigger gun.
Install the nozzle for the job.
1. Lock the bucket with water on the base unit or
connect the base unit with a water supply. Start at the
Содержание BY-PW02-B2Z-060-02
Страница 17: ...17...