Reading Stove Company Pine HF-75, Руководство пользователя

Страница: 13 / 22

Pine HF-75
Website: www.ReadingStove.com Facebook & Twitter: @ReadingStove
13
Section 4: Operating Instructions
A. The Controls:
The heat output or rate of combustion is controlled by the primary combustion air controls.
When the dial is turned all the way to the left, the setting is “high burn”. When the dial is turned all the way to the
left, allowing just the slightest opening, the setting is “low burn”.
1. The Shaker Tool – Each Pine HF-75 comes with a tool which attaches to a fitting on the side of the
base of the stove and is used to shake the grate to remove ashes.
2. The Barometric Damper – The draft in the chimney will change depending on how cold it is outdoors,
the burn rate of the stove, and wind conditions. A barometric damper is basically a vacuum relief valve for
the chimney system. It is considered good practice to install one in all coal burning applications.
B. Starting a Coal Fire:
1. Open the loading door on the top of your stove
2. Put a single layer of match-light charcoal on the grate
3. Open the air control to high burn
4. Light the charcoal with a long match or a rolled up piece of newspaper
5. Close the loading door
6. Allow the coal to burn until it is glowing (Approx. 10-15 minutes)
7. Slowly open the loading door; keeping your face and body clear of the opening in the event of any
combustible gases that may have accumulated
8. Gently sprinkle a single layer of coal over the bed of the burning charcoal and close the loading door
9. Once the coal is burning, add more layers of coal through the hopper lid without exceeding maximum
capacity.
10. Close the loading door and reset the primary air control for the desired heat output.
C. Refueling:
WARNING: It is recommended that you wear gloves whenever working with a hot stove.
With Hopper –
1. Turn the air control dial to the left (counter clockwise), allowing more air flow – “high setting.”
2. Gently shake down the dead ash, once sparks begin to shower down, stop shaking.
3. Open the loading door on the top of your stove.
4. Add coal into the hopper, not to exceed the capacity of the hopper.
5. Close loading door on the top of your stove.
6. Allow the coal to burn (approx. 5-10 minutes).
7. Reset the primary air control for the desired heat output.