re3D GIGABOT 3+, Быстрый старт, Страница: 17 / 32

IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
When viewed from below, turning the knob
clockwise will raise that corner. Turn the
leveling knob to raise the bed until the nozzle
is close but not touching the shim stock. This
gap is needed because when raising the other
corners of the bed, this corner will also raise
slightly. Repeat this process at all corners of
the bed.
17
B10
For the final adjustments of the corners, turn
each knob so that there is slight friction
between the shim stock and the nozzle.
Repeat this process until all corners have the
same friction.
B11
Use the 8mm combination wrench to
gradually tighten the M5x12 hex head screws
at each corner. Periodically use the shim stock
to check the bed level, since tightening the
hardware on the rails may cause them to move
slightly. The bed cross rails should be secured
and acceptably level to the nozzle after 2-3
total passes.
B12