EZ-RA6
EZ-CC6
SELECTED MOUNTING ACCESSORIES
TYPICAL PERFORMANCE
Rack Adapter
for 6 Increments of 1/6 Rack Width
Component Chassis
for 6 Increments of 1/6 Rack Width
EZ-UCB2
Under-Counter Brackets
1/6 or 1/3 Rack Width
Use In Place of Filler Panel
Holds Adapters and Cables
Mounts in EZ-CC6 and EZ-RA6
Complete accessory listing available at: rdlez.com
Copyright © 2009 Radio Design Labs, Inc. RDL, Radio Design Labs and the RDL logo are registered trademarks of Radio Design Labs, Inc. Data reflects product at publication time, subject to change without notice. “Made in USA” applies to all EZ products except power supplies.
Input: > 10 k
Ω
, -10 dBV nominal on RCA jacks, -13 dBV Min. (for 10 W out), +22 dBV max.
Gain: Off to 32 dB
Outputs (2): Left and Right, 10 Watts RMS into 8
Ω
per channel or 8 Watts RMS into 4
Ω
per channel, switch-selectable output impedance
Frequency Response: 35 Hz to 20 kHz (±1.5 dB, 10 Watts)
THD+N: < 0.25%
Crosstalk: < -68 dB (1 kHz)
Phantom: Switch-selectable 24 V (IEC 1938: 1996-12)
Noise: < -70 dB (below 10 Watts)
24 Vdc power supply current: 160 mA (idle), 1000 mA (max.)
Power supply input voltage: 100 to 240 VAC
Warranty: 3 Years; contact RDL technical support department for assistance
Case dimensions: 5.75” (14.6 cm)W x 5” (12.7 cm)D
Mounting size: 1/3 rack width
891-1510
EZ-DC2
EZ-SMB2
TYPICAL PERFORMANCE
Desktop Chassis
1/3 Rack Width
EZ-UCB2
Under-Counter Brackets
1/6 or 1/3 Rack Width
Surface Mount Bezel
for 1/3 Rack Width Products
EZ-SD2
Storage Drawer
1/3 Rack Width
Copyright © 2009 Radio Design Labs, Inc. RDL, Radio Design Labs and the RDL logo are registered trademarks of Radio Design Labs, Inc. Data reflects product at publication time, subject to change without notice. “Made in USA” applies to all EZ products except power supplies.
