M0140.docx | Rev 2.5 | Modified on 26/06/2019 | © Remote Control Technologies Pty Ltd
7 | 16
Installation Guide
1. Install the control unit in a suitable location in full visibility of the driver, preferably on the instrument panel.
2. Refer to the wiring table below and the wiring diagram in this manual to wire up the control unit. It is
recommended that the wiring loom be installed alongside the OEM engine wiring ensuring that it is secured
at regular intervals; this will provide protection from heat and abrasion, and any other excess damage that
may occur with extended vehicle operation. When securing the loom to the OEM engine wiring, ensure
that the loom is away from moving vehicle parts which could lead to loom damage.
3. Install the sensors/ switches (see below for more detail). All sensors/ switches should be installed using a
suitable thread sealant. All sensors should be installed using a suitable thread sealant.
Note
RCT recommends that all electrical connections be treated with Electroguard grease (part number 2800).
Wiring Connections
Pin No.
Colour
Description
1
Purple
Start input
2
Yellow/Blue
ETR output (4 A max)
3
Black
0 Vdc earth
4
Red
7 - 35 Vdc ignition
5
Brown
Idle control output (4 A max)
6
Green
Fault alarm
Pin No.
Colour
Description
1
White
Coolant level sensor
2
Pink
Engine oil pressure switch
3
Yellow
Engine coolant temperature sensor