www.modellmarkt24.ch
Take your time and do several dry installation.
Once near, if necessary, to the cyano pointed to test the amplitude
control surfaces.
Supports servos can be glued with epoxy 5min and the
horns will be glued to the cyano or with a mixture of epoxy and silica.
-Pass the cables through the holes planned. (To facilitate this step can
make use of a piano wire) then solder the plugs.
Before installing the servos, put in neutral for the aileron servos. Provide
an offset of 20 ° for the flap servos. This is to be a large movement of the
flaps.
You can now install the servos and connect the rods. Favor a
mechanical adjustment.
To lock the rod or the operating clearance is too high, you can add a
drop of cyano on the spreader and the horn.
www.modellmarkt24.ch
