RCO R-COD 500, Установка, наладка, использование

Страница: 13 / 14

R-COD 500 & R-COD 500 IR
PERFORMING A FACTORY RESET
13
Performing a factory reset
Normally a factory reset is only performed when the unit is commission or recommissioned,
or when the system code has been lost. All information contained in the memory is erased.
The system code is reset to the default (1 2 3 4).
After a factory reset, change the system code upon commissioning so that no
unauthorised person can use the system code to reprogram access codes.
If the system code is known
Description Quick guide Indication
1. Enter the system code (default 1 2 3 4). x x x x
2. Select menu 9. Confirm by pressing #. 9 + #
3. Press 1 for master reset. 1
4. Confirm by pressing #. A beep confirms that the unit
has been reset. # –
If the system code is not known
Description Quick guide Indication
1. Press and hold 0 when powering up the unit.
2
—0—
2. Press 1 and then # to confirm master reset. A beep
confirms that the unit has been reset. 1 + # –
2
This assumes that power to the code lock has been interrupted. The normal procedure is to temporarily
interrupt the supply from the distribution box and get an assistant to hold down the 0 button while power is
restored. Then press 1 and then #.
!