background image

3

FCC Regulatory Statements 

This device complies with Part 15 of the FCC Rules. Operation 
is subject to the following two conditions: 

(1) This device may not cause harmful interference. 
(2) This device must accept any interference received, 

including interference that may cause undesired 
operation. 

This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to part 15 of the 
Federal Communication Commission (FCC) rules. These limits 
are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if 
not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a 
particular installation. If this equipment causes harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by doing one or 
more of the following measures: 

  Reorient or relocate the receiving antenna. 

  Increase the separation between the equipment and 

receiver. 

  Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected. 

  Consult the dealer or an experienced radio/TV technician for 

help. 

NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY 
CHANGES OR MODIFICATIONS NOT EXPRESSLY 
APPROVED BY THE PARTY RESPONSIBLE FOR 
COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE 
USER’S AUTHORITY TO OPERATE THE EQUIPMENT. 

Содержание CLiK64-TR

Страница 1: ...tion of the transmission Pressing and holding the button down only transmits one pulse This reduces unintentional transmissions and conserves battery life 2 Release and press the button for one second again to send another transmission 3 If the light on the transmitter does not light up when you press and hold any button replace the battery CLiK64 TR1 CLiK64 TR2 CLiK64 TR4 ...

Страница 2: ... Push the coin shaped battery out of its holder and replace it with a CR2032 battery being careful to place the positive side on top 4 DO NOT install the batteries backwards The device will be damaged 5 Snap close the case 6 Test the transmitter and look for the red LED light to flash when a button is pressed for one second CLiK64 TR Battery Replacement ...

Страница 3: ...th the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment causes harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by doing one or more of the followin...

Страница 4: ...ce L exploitation est autorisée aux deux conditions suivantes 1 l appareil ne doit pas produire de brouillage et 2 l utilisateur de l appareil doit accepter tout brouillage radioélectrique subi même si le brouillage est susceptible d en compromettre le fonctionnement CAN ICES 3 B NMB 3 B RF Exposure Information This equipment complies with ISED RSS 102 radiation exposure limits set forth for an un...

Отзывы: