9. Install the spark plug into the engine cylinder (7-8lbs torque).
Installing the RCGF 60cc twin cylinder engine
on Your Airplane
Note:
The RCGF 60CC twin must be installed on at least a 9.5mm [3/8”] thick 5-phy
plywood firewall.The firewall must be securely glued to the airplane. Use triangle stock
and pin the firewall with hardwood dowels to reinforce the firewall glue joints. Never
install the RCGF 60cc twin onto a firewall thinner than specified because it may fail due
to the power of the engine.
Note:
The length of the engine from the back on the engine mount to the face of the
propeller washer is 169 mm
1. Please check engine size chart (on the back cover of this manual) to drill the engine
mounting bolt holes.
2.
Install (4) 5mm blind nuts into the back side (non-engine side) of the firewall. Install
the engine to the firewall using(4) 5x45mm SHCS with 5mm lock washers and flat
washers(not included) with the included standoffs. Use threadlocking compound, such as
Threadlocker
,on the screws where they thread into the blind nuts.
3. Install the fuel tank in the airframe. Use only gasoline approved fuel tank and fuel lines
and a gasoline approved stopper. One line should go to the carburetor and the other is to
be used as a vent (a vent line is simply an open ended fuel line from the fuel tank which
exits the engine compartment or the fuselage; most vent lines exit at the bottom of the
firewall).You can fill the tank by using the carburetor
line as fill line if you have access to
it or install a third line to be used as fill line. Installing a third line is the cleanest and
easiest way to add fuel. An alternative fueling set up is a 2-line system with a T-fitting
approved for gasoline use. Be sure to use a filler plug with either a 2 line or 3 line set-up.
It's a good idea to add an extension to the vent line as shown, that goes up and to the
rear of the tank. This helps to avoid draining fuel from the tank when the model is pointed
down.