RCF MX 1822, Инструкция по установке и эксплуатации

Страница: 21 / 32

21
ENGLISH
FEATURES - REAR PANEL
32. RECORD (L&R)
- Unbalanced (RCA) LINE level
outputs that can be connected to an external unit
such as a recorder. Nominal output level -10dBv.
33. PLAYBACK (L&R)
- Unbalanced (RCA) LINE level
Left/Right inputs that route the output of a tape
machine or CD player back into the
MX 1822
main
MIX. Nominal input level -10dBv.
Note: Some recorders (tape/minidisk/CD-R) internally
route the input signal back to the PLAYBACK
connectors to allow monitoring while recording. If
the machine you intend to use operates in this way,
disconnect the playback connectors from the
MX
1822
or a feedback loop will occur.
34. +48V PHANTOM POWER
- This recessed switch
connects standard 48V PHANTOM POWER to all the
MIC inputs for use with capacitor/condenser MIC or
active Dl boxes that require phantom power.
Unbalanced MIC must not be used when the
phantom power is switched on as damage may
occur. The switch is recessed to prevent accidental
operation and should be operated using a plastic
ball-point pen or similar instrument. A warning LED
on the front panel indicates that the Phantom Power
is turned on.
If any channels require the 48V to be disconnected
see options section (page 23)
35. OUTPUT (L&R) - Balanced XLR output connectors
to amplifiers/multitrack recorders etc.
36. INSERT - A send/return for the main output
on a single TRS (Tip, Ring, S leeve) jack. Use a ‘Y’ -
cable to connect the tip to the input and the ring
to the output of a serial effects device (compressor,
equalizer, etc.)
37. AUX A POST - Balanced compatible output on
1/4” TRS jack.
38. AUX B PRE - Balanced compatible output on
1/4” TRS jack.
39. AUX INPUT (stereo return) - Balanced stereo
input on 1/4” TRS jacks for CD players, effects returns,
drum machines etc
For mono operation use the LEFT/MONO connector
only.
39
35
32
33
34
36
37
38