1
ENGLISH
{
Amplifier mode selector
Before turning the amplifier on, set the amplifier mode selector to the right position among
PARA
(mono),
STEREO
and
BRIDGE
. See the section ‘Operation modes’.
}
Amplifier output to loudspeakers
(SPEAKON connector, one per channel)
In stereo and mono modes, both outputs can be connected; in ‘bridge’ mode, connect the output 1
only. See the section ‘Operation modes’.
q
Power cable input
Connect the power cable only to a mains socket outlet with a protective earthing connection.
w
Openings for heated air exit.
Do not obstruct these openings !
OPERATION MODES
• STEREO MODE
Ensure the amplifier is switched off, then set the
MODE
selector to
STEREO
.
In stereo mode, the 2 channels operate independently and each front panel level control affects the
respective output.
Minimum nominal load impedance is 2 Ω per output.
Loudspeakers can be connected to either the SPEAKON output 1 (left channel) or 2 (right
channel).
As alternative wiring, the amplifier output 2 is also available on the SPEAKON connector of the
output 1 (pins: 2+ positive, 2– negative).
L
R
+
–
1+
1–
LEFT
(min. 2Ω)
L
LOUDSPEAKERS
+
–
1+
1–
(min. 2Ω)
RIGHT
R
WARNING: TURN OFF THE AMPLIFIER
BEFORE CHANGING MODE!
LEFT
RIGHT
i
MIXER
