When making connections, keep in mind the fol-
lowing:
•
the overall load impedance of all the speakers
connected to the audio line
must not be lower than
the impedance selected on the amplifier output,
in
order not to risk damaging the amplifier.
•
to ensure correct audio reproduction,
make an
"in phase" connection,
in which the +/- polarity of
the amplifier output corresponds to the polarity of the
speaker input.
A CLOSER LOOK:
When two speakers
reproduce the same frequencies but with
phase differences, these frequencies may
be annulled. In sound systems, speakers are often
situated in adjacent positions and the sound waves
produced interact with each other. If a speaker is con-
nected incorrectly; i.e. the polarity of the audio line
conductors is inverted, the audio signals are tran-
smitted with differences in phase and correct repro-
duction is therefore jeopardized.
Constant voltage systems connections
1. Attach the optional
TD 106
transformer inside the
speaker in position
C
(Fig. 4, page 23).
2. Make the connections as indicated in the instruc-
tion manual of the transformer, making sure to
use standard terminals.
VERY IMPORTANT:
To prevent dama-
ge to the speaker, it is
indispensable
to select a maximum power of
3W on the TD 106 transformer,
proceeding as
described in the instruction manual of the tran-
sformer.
6. Service
If the product seems to be not operating correctly,
before contacting the service centre, carry out all the
tests the may confirm the malfunction. In many pro-
ducts taken to the service centre, it is not possible to
reproduce the malfunction indicated because the pro-
blem is probably to be found elsewhere in the sound
system. If the product does require service, place it in
its original packaging and take it to your local dealer
or to the nearest service centre.
9
7. Appendix A- Input cables
For connecting the speaker use cables with an ade-
guate cross-section. The greater the distance
between the amplifier and the speaker, the larger the
connection cable cross-section should be.
To prevent inductive phenomena from giving rise to
humming or disturbance that jeopardize the effective
operation of the audio system, the speaker cables
should not be run together with electrical energy con-
ductors, microphone cables, or low level audio lines
(e.g. LINE level).
To facilitate the ‘’in phase’’ connection of the
speaker, use bipolar cables that have markings to
distinguish the polarity (e.g. insulation of different
colours, conductors of different colours, ect.).
To minimize the inductive effects (hum) due to cou-
pling with surrounding electrical fields, use cables
with conductors braided together.
8. Specifications
Type
Wall speaker
Attachment system
Surface mount
Nominal/maximum power
3 / 6 W
Impedance
4
Ω
Frequency response
120 – 10,000 Hz
Sensitivity
93 dB (1m/1W)
Maximum sound pressure
102 dB (1m/max. power)
Angle of coverage
[4000 Hz]: 40° horizontal x 60° vertical
Dimensions (W x H x L)
234 x 200 x 120 mm
(9.21” x 7.87” x 4.72”)
Maximum protrusion
120 mm (4.72”)
Weight
0.7 kg (1.5 lbs.)
Disclaimer
RCF S.p.A. applies a company policy based on constant research and development. With the aim of constantly improvig
our products, we reserve the right to make any aesthetic or functional modifications at any time and without prior notice.
RCF is a registered trademark of RCF S.p.A.
Any other trademark mentioned herein is a trademark or registered trademark of the respective owners, who we gratefully acknowledge
©2002 RCF S.p.A.. All rights reserved. Printed in Italy.