RCF AYRA EIGHT, Руководство пользователя

Страница: 7 / 16

7
ENGLISH
BEFORE TURNING ON
THE SPEAKER
HOT GND
BAL. XLR
COLD
CONNECTIONS
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
On the back panel you will find all the controls, the signal and current inputs.
At first verify that the voltage selector on the speaker is in proper position for your country
(115 Volt or 230 Volt).
The switch shall be in proper position (unless moved from unauthorized people), but a
fast check will avoid problems. In case is necessary to change the voltage please call your
vendor or authorized RCF SERVICE CENTRE. This operation require the substitution of the
fuse value and is reserved to an RCF SERVICE CENTRE.
At this point you can connect the power supply cable and the signal cable, but before
turning on the speaker make sure that the volume control is at the minimum level (even
on the mixer output). It is important that the mixer is already ON before turning on the
speaker. This will avoid damage to the speakers and noisy “bumps” due to turning on parts
on the audio chain. It is a good practice to always turn on speakers at last and turn them
off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
BEFORE CONNECTING
THE SPEAKER