Attach the L-brackets to the motor mount
3
⚠
Assemble data
acquisition board,
motor mounting part,
and lower structural part
4
Position 2kg load cells parallel to each other and
tighten
5
6
Connect in the following order: the load
cells, the power cables, and the USB cable
Bracket
4x M4 5mm
Motor mounting part
2x Spacer
2x M4 Washer
2x M4 12mm
4x M4 5mm
Do not tighten yet
Data
acquisition
board
Parallel
Tighten 4x
Tighten 4x
Top View
Secure the 3 wires
along the edge
using 4 tie-wraps
Positive input (+)
(red wire to
power supply)
Bottom view
3x Connect load
cells under circuit*
USB cable
*Load cell connector
orientation is not important
Ground input (-)
(black wire to
power supply)