V1.62 Last Revised 4-27-2010
Recharging:
The supplied lithium glow driver as received will need to be
charged. A fully discharged glow driver will take approximately 8 hours to
charge. Included with the unit is a regulated 5VDC wall wart adapter that
supplies power to th
e glow driver’s
internal
lithium ion charger. Simply
connect the adapter’s plug to the receptacle at the bottom of the unit and then
plug the adapter into AC 110V-220V 50/60Hz power. Once powered, an LED
will light within the glow driver case during the charge cycle. When completed
charging, the LED will turn off. Charge times will vary, up to 8 hours for a
complete charge.
DO NOT USE ANY OTHER METHOD TO CHARGE
YOUR GLOW DRIVER!
Start-up Detay
Glow drivers shipping after Sept 2008 now have the ability for the user to
turn on or off a start-up delay feature commonly used for pattern flying). To
set the delay, remove the four screws on the back side of the case, and locate the dip switch on the back side of the board.
Handling:
Please take proper care of your glow driver. It is a sophisticated piece of electronics equipment. While housed in
a sturdy plastic enclosure, the case will not tolerate being dropped on hard surfaces nor being exposed to raw fuel. We
recommend that you keep it away from fuels and substances which may attack the plastic. Note that we also have a rubber
boot available which helps protect your glow driver. See our website for details.
Battery Information & Precautions
Do not attempt to service your RCATS lithium glow driver or its batteries. Danger of explosion if battery is
incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer’s instruction.
Your RCATS Lithium glow driver uses a specially designed
Lithium-Ion battery pack. Proper care and usage of the battery pack will provide many hours of safe operation. Ignoring these
warnings can lead to accidental ignition or explosion and bodily injury. Do not damage the battery pack or glow diver unit.
Keep it away from children. Do not drop, mutilate, disassemble, puncture solder, or alter the batteries or unit in any way. Keep
it away from any heat source above 130º F. Any Lithium-Ion battery pack will eventually become unable to hold a charge with
time. A battery pack should be replaced when its discharge times become short. Due to the projected recharge intervals of the
RCATS lithium glow driver, this should not be of any concern to the user. Never use a battery pack that appears corroded,
discolored, or warped. While a recharging battery, the unit may become warm to the touch. A damaged pack may produce
extreme heat or give off a burning odor. If in the event of a bad pack, use extreme caution with any liquid residue from a
leaking battery pack: Avoid contact with the residue. If you come into contact with it, wash the affected area immediately. If any
residue gets into your eyes, do not touch or rub the area around your eyes. Rinse immediately and seek medical advice.
Disposing of a Battery Pack
NEVER DISPOSE OF A BATTERY PACK IN A FIRE. There is a danger of ignition or explosion. Discard of used battery packs
in accordance with your local regulations. Contact your local waste management officials for information regarding
environmentally sound disposal of Lithium-Ion (Li-Ion) batteries.
If you encounter any difficulty with your RCATS Smart Lithium Glow Driver, please don’t hesitate to contact us.
Email:
WARRANTY
RCAT SYSTEMS WARRANTS THAT THIS PRODUCT OF ITS MANUFACTURE SHALL BE FREE OF DEFECTS FOR A
PERIOD OF TWO YEARS AFTER THE DATE OF PURCHASE. UNDER NO CIRCUMSTANCES SHALL RCAT SYSTEMS
BE RESPONSIBLE FOR ANY DAMAGE TO THE PRODUCT WHICH IS CAUSED BY NEGLIGENCE, MISUSE, OR
MISTREATMENT OF THE PRODUCT. 2YR WARRANTY DOES NOT APPLY TO CASE, BATTERIES (1 YR WARRANTY)
OR GLOW PLUG CLIP. ANY PRODUCTS MODIFIED OR ALTERED IN ANY WAY WILL NOT BE HONORED UNDER
WARRANTY. THE WARRANTY OF REPLACEMENT SHALL TERMINATE WITH THE WARRANTY OF THE PRODUCT.
PRODUCTS RETURNED TO RCAT SYSTEMS FOR WARRANTY SERVICE SHALL BE DONE SO AT THE EXPENSE OF
THE BUYER. PRODUCTS RETURNED TO BUYER WILL BE DONE SO AT THE EXPENSE OF RCAT SYSTEMS.
Proprietary Rights
The Buyer acknowledges that RCAT Systems has proprietary interest and intellectual property rights in the Hardware,
Software and/or Products it sells, unless mentioned otherwise. The Buyer shall not (i) remove any copyright, trademark, or
evidence of RCAT System’s ownership or proprietary interest or notices contained in or on the Products delivered, (ii)
reproduce or modify any Software, Hardware, or Products or make any duplicates/copies thereof (iii) reverse engineer, reverse
assemble, or decompile Software or Products or documentation thereof, except in accordance with this agreement.
Prices and specifications subject to change at any time, without prior notice
Start up
Delay Dip
Switch
