RCA VR648HF, Руководство пользователя

Страница: 31 / 42

Chapter 5 31
Chapter 5: Additional Information
Troubleshooting
In this section, you will find answers to common recording, playback, and general VCR questions. Consulting with this
section first when there is problem may help you answer common questions.
General VCR Problems
No power
• Make sure the VCR is plugged into a working outlet.
• Make sure connections between devices are correct and snug.
The VCR does not respond to the remote control
• To put the remote control in VCR mode, press the VCR button first. The remote control should then operate the
VCR.
• Make sure there are no objects between the VCR and the remote control.
• The remote might need new batteries.
• Remove the remote control’s batteries and press the number 1 button for at least 60 seconds. Release the 1 button
and replace the batteries. This resets the factory default settings, which may require reprogramming to operate other
components.
The remote control no longer operates an RCA, GE, Proscan, or Scenium TV
• Press the TV button to put the remote control in TV mode. The remote control should then operate the TV.
There’s poor quality or no picture for normal TV viewing
• If using RF coaxial cables to connect the VCR to the TV, make sure the VCR indicator is not displayed on the VCR’s
front panel. Press the TV•VCR buton to toggle between VCR and TV-viewing modes.
If using A/V jacks and cables to connect the VCR to the TV (and the remote is compatible with yout TV), press the
remote control’s INPUT button when in TV mode to access the TV’s Video Input Channel.
• Tune the TV to an active channel.
• All cables should be securely inserted and connected to the proper jacks.
Cannot select channels over 69
• Cable channels over 69 can only be selected if Signal Type: CABLE/ANTENNA is set to CABLE in the CHANNELS
menu. Go to page 28 for instructions.
The timer indicator flashes on the VCR front panel
• The clock is not set. Go to page 9 for instructions.
• Make sure there is a tape in the VCR when a timer recording is set.
Rewind does not operate
• Make sure the tape isn’t already rewound.
• Make sure the tape isn’t damaged or broken.
The incorrect time or date is shown
• A power interruption may have occurred and Automatic Clock Set was not turned on or did not work properly.
Check the
Set Time Zone and Daylight-Saving settings in the TIME menu.
• Make sure the VCR or cable box is tuned to the time data channel (check with your cable service provider for
information about time data).
• Auto Clock Set is not supported in all areas or by digital satellite receivers. Set the time and date manually using the
TIME menu. Go to page 9 for instructions.
The time did not adjust for Daylight-Saving Time
• Make sure the Daylight-Saving Time feature is set correctly in the TIME menu.