Setting Up the VCR
Startup
3. Turn on the TV.
A.
Turn on the TV.
B
. If you used one of the basic hookups, tune the TV
to the channel selected with the
CH3 CH4
switch
on back of VCR.
If you used one of the advanced hookups, tune the
TV to the TVÕs video input. (See TV ownerÕs
manual for details.)
4. Turn on the VCR.
A.
Press
POWER
on the remote.
5. Place channels in the VCR’s memory.
The first time you turn on the VCR or after a power
interruption, perform the
AUTO CHANNEL SEARCH
so that your VCR can locate the channels available
through your signal typeÑcable or antenna. The
signal type is automatically selected when you perform
the
AUTO CHANNEL SEARCH
function. Also, if you
change the signal type, you will need to perform
AUTO
CHANNEL SEARCH
again.
A
. Press
MENU
to display the
VCR MAIN MENU
on
the TV screen. If this menu does not appear:
¥ Make sure TV is tuned to same channel as the
CH3 CH4
switch on the back of the VCR or the
TVÕs video input (refer to TVÕs manual).
¥ Press
MENU
again.
¥ If you use a basic hookup, check
VCR
indicator
in display panel Ð it should be on. Press
TV•VCR
to turn it on.
¥ Check the connections.
B
. Press
4
to display the
CHANNELS
menu.
C
. Press
1
to begin
AUTO CHANNEL SEARCH
.
The VCR automatically selects
CABLE
(cable TV)
or
ANTENNA
. If you need to change the setting
manually, press
3
.
Wait until the channel numbers stop changing. This
takes about one to two minutes. The TV will then tune
to the lowest channel found. Pressing
CHANNEL
up or
down will select only the active channels.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Set Clock
4 Channels
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 VCR Plus+ Channel List
0 Exit
AUTO CHANNEL SEARCH
Now scanning channel 45
Press any key to cancel
8