RCA U1000, Руководство пользователя

Страница: 8 / 28

Installing the Phone
The U1000 may be connected to either two 2-line (RJ14C) wall jacks or four single line (RJ11C) wall jacks to
accommodate all four lines. The U1100 does not require connection to telephone lines.
Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed on a level
surface, such as a table top or desk.
Install 5 AAA-size alkaline batteries (not included) for backup power in the event of a power failure. To open
the battery door, find the tab on the top of the battery compartment. Push down on the tab and pull away
from the phone. A flat bladed screw driver may be needed. Insert the batteries only as shown on the diagram
inside the battery compartment.
NOTE: If the low battery icon appears in the display, you will need to replace the batteries to ensure unit
operation during a power failure.
IMPORTANT: If you are not going to use the telephone for more than 30 days, remove the batteries to avoid
battery leakage and damage to the unit.
Plug the AC power supply cord into the power jack on the back of the base and the other end into an
electrical outlet.
CAUTION: To reduce risk of personal injury, fire, or damage, use only the adaptor provided. Model
#KSAS0050750080VUD. Unison system is a Class (Classe) 2 Power Source
1. Connect the telephone line cords:
If you have two 2-line wall jacks installed in your home or office, plug one end of the straight telephone line
cord tagged as “Line 1+2” into the jack marked “LINE 1+2” on the back of the U1000 base. Plug the other
end of the line cord into the wall jack. Plug the other line cord into the jack marked “LINE 3+4” on the back of
the phone, with the other end plugged into the wall jack as well.
If you have four single-line wall jacks installed in your home or office, simply plug each single line cord into
the corresponding port on the back of the U1000 base phone.
2. Connect the handset cord
​ :
Connect one end of the coiled handset cord to the jack on the side of the base and the other end into the
jack in the handset, then place the handset in the cradle.
3. Check for a dial tone:
Lift the handset and listen for a dial tone. If you hear a dial tone, the phone is properly installed.
7