RCA Stereo Receiver with Remote Control, Руководство пользователя

Страница: 12 / 16

12
TROUBLESHOOTING
If the receiver is not working as it should, the following suggestions might help. If you follow the suggestions in this chart and the receiver still
does not work properly, contact your local RadioShack store for assistance.
Problem Cause Suggestion
Power does not turn on. Power cord is disconnected. Plug in the power cord.
No sound. Incorrect connections. Check and correct the connections.
The mute function is activated. Press MUTING .
The volume is turned down. Turn up the volume.
Speaker wires are disconnected. Connect the speaker wires.
Neither set of speakers is selected. Press
SPEAKER A
or
B
.
Both SPEAKER A and B are selected when only one set
of speakers is connected.
Press SPEAKERS A or B to turn off the speakers
that are not connected.
TAPE MONITOR is selected. Press TAPE MONITOR so TAPE MON turns off.
Sound from only one speaker. One of the speaker wires or the input cord is
disconnected. Check all connections.
BALANCE is set too far to one side. Set BALANCE to the center position.
High noise level. Station not correctly tuned. Adjust tuning.
Antenna not connected. Connect antenna.
FM antenna still coiled or is not pointing in the correct
direction. Stretch both ends of the antenna taut and reposition
the antenna.
AM loop antenna not pointing in the correct direction. Adjust the AM loop antenna.
Noise is coming from another electrical appliance. Try using an AC line noise filter to reduce the noise.
Automatic tuning does not stop when
searching for stations. Stations are too weak. Use a better antenna.
Remote control does not work. Batteries are weak or missing. Install fresh batteries.
Poor angle or too great a distance from the remote sensor
window. Use the remote within the effective range.
There is an obstacle between you and the remote sensor
window. Change your position or remove the obstacle.
A fluorescent light is shining on the remote sensor
window. Turn off the light.