THE DIGITAL CD CLOCK RADIO
3
Setting time
Slide the selector switch to CLOCK.
1
Press
TUNING TIME DN
or
UP
to select current
time.
2
NOTE
NOTE
NOTE
NOTE
NOTE
:
1. Press and hold
TUNING/TIME DN
TUNING/TIME DN
TUNING/TIME DN
TUNING/TIME DN
TUNING/TIME DN
or
UP
UP
UP
UP
UP
to skip fast
2. The time display is in 12-hour format. AM/PM indicator will light to show AM
or PM time respectively.
Setting Wake to Tone
To set clock and wake time, slide the selector switch on the top
of the unit to select between setting LOCK, WK1, WK2 and
CLOCK.
1
2
THE DIGITAL CD CLOCK RADIO
Protection against main power failures:
1. Remove battery compartment door (located on the bottom of the radio) by
applying thumb pressure to area indicated on battery door and then lift the door
out and off the cabinet.
2. Connect a 9-volt battery connector plug. (6LR61 or NEDA 1604A)
3. Insert battery in the compartment and replace the compartment door.
NOTE:
Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be
used but memory holding time will be substantially reduced. Memory holding time for a
fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which
should take care of short, nuisance-type AC power failures. To preserve battery life, the unit
should remain plugged into an AC outlet. As the battery gets older, its voltage drops and
memory may be lost. Be sure to replace the battery periodically. Battery should be removed if
the unit will be stored for more than one month. Leaky battery can badly damage the clock
radio.
2
The Display
Wake 1 to
Tone / Radio / CD
Radio frequency
scale
Nap Indicator
Wake 2 to
CD / Radio / Tone
Radio band
indicator
AM/PM
indicator
EN
Tip:
Tip:
Tip:
Tip:
Tip:
Slide the
DIMMER
DIMMER
DIMMER
DIMMER
DIMMER
switch on the back of the unit between
ON
ON
ON
ON
ON
and
OFF
OFF
OFF
OFF
OFF
to
adjust the LED display brightness.
1
Tip:
Tip:
Tip:
Tip:
Tip:
1. With the GRADUWAKE
GRADUWAKE
GRADUWAKE
GRADUWAKE
GRADUWAKE feature,
the alarm tone volume will increase
gradually to its maximum in about 30
to 45 seconds.
2. You cannot adjust the volume
level of the alarm tone.
Slide the selector switch to select
WK1 or WK2.
2
If selector switch is set to WK1,
press
WK1
to select wake
to tone .
Press
WK2
if selector switch
is set to WK2 to select wake to
tone .
Press
TUNING/TIME DN
or
UP
to set the wake time
.
3
1
3
2
2
You can choose to wake to Radio, CD or tone.
RP3750 EN
3/11/02, 10:40 AM
6-7